2016/07/09

CO2 Laser: DIY Vacuum gauge

CO2 Laser: DIY Vacuum gauge


I've decided to build a low-pressure pirani gauge to detect the leak in the tube. This site describe how to make a pirani gauge from scratch. I've use common flashlight lamp bulb even if they get low filament resistance. Actually my gauge work but is very sensitive the length of the wiring between the light bulb and the circuit get a significant resistance and change the value of the measure.

I've made own circuit on LTSpice, you can download it here:
The circuit
Tension by the equivalent resistance
This circuit maintain the resistance and so the temperature of the bulb constant. The voltage need to keep the filament at the same temperature is link to the energy take away by the air molecules and so the pressure. At atmospheric pressure the air takes away a lot of energy by convection but under medium vacuum air is much thinner and the convection much less effective, so you need less current to maintain it to the same temperature.

CO2 Laser: First test

CO2 Laser: First test

I wire the tube and test it with my homemade transformer (Inspire by this site) and a ZVS driver.

First test
On the first test the vacuum was too poor, so the plasma was filamentous. Form the left to the right you can see my vacuum pump, with a final vacuum of 15 microns, the 30V 5amps max power supply, the ZVS inverter with the transformer just behind and the tube with the plasma starting form the center.

Few tests later
On this picture the plasma is fully form, the power supplied about 5 amps at 30 volts. The tube contain only air no CO2 yet.

CO2 Laser: The tube assembly

CO2 Laser: The tube assembly

I've found an easy way to align the optics and to keep the whole thing together, I use two metallic profile that I weld.
The glass tubing is a old neon with cut ends. To cut it I use thermal shock, with a glass drill you make a gash around the tube, then with a welding torch you quickly heat this gash. Usually this shock is enough to cut the glass. This process is better explained here.

The whole thing on my workspace

clean picture of the tube

CO2 Laser: The begining

CO2 Laser: The begining





I've decided to start to build a CO2 laser after seeing some on internet, like this one or this one. Moreover I've already made some project link with vacuum and high voltage. 
So here we are, I've start to build the main part the tube.
One end of the tube
The image above is a compensation plate, between the steel disk rubber flange which insure the tightness and with the 3 screws I can adjust the mirror.
The welding
Vacuum pump side
and the other side
transverse view of the tube
the whole tube

2016/07/05

Asynchronous motor

Asynchronous motor experimenting

 I found this kind of motor in a washing machine. The main advantage for this kind of motor is that you can regulate their speed with a simple variac. The power connector is a six pin connector, 2 pin for the tachometer, 2 for the bridge and 2 for the power supply, the variac in this case. Thank to the embedded tachometer you can actually measure the speed with a simple multi-meter.

The motor

And the connector

The setup, from left to the right:
The variac, the speed voltmeter and the motor
I've found the doc about this motor, you can get it here

Tags: Selni, U2.40.01.M.17, Asynchronous motor